![]() Once the head conforms, you can back off on the tension a little if desired. Keep it fairly tight over a number of days, tightening periodically to take up slack as the head stretches, and that slack at the snare beds will go away. It might take a little bit of time and tension to stretch the bottom head so that it conforms to your snare bed. (My 1950s Slingerland Radio King also has deep, narrow beds.) A lot of newer drums have more subtle snare beds that you might not notice unless you set the drum shell down on a perfectly flat surface and looked carefully. On some vintage drums, the snare bed is narrow and deep, making it visually obvious. It creates a slight curvature to the bottom head so that the snares can maintain good contact all the way across the head. By carefully processing the top bearing edge to make it a rounder, 60-degree 2R edge, deeper fundamental tone has been brought out. That's called a snare bed and it's a characteristic of almost every snare drum out there. Therefore, the shape of the bearing edges is one of the most important factors in a drums sound.STAR drums feature a bearing edge shape as shown in the. We have tuned the popular Maple Custom Series snare drum to produce even greater sensitivity and tonal control. The bearing edge is even except where the snares cross over the bearing edge, on the strainer and butt sides. Complementing the seamless shell design is our unique combination of bell-flanged bearing edges and crimped snare beds, which ensure the widest tuning. ![]() Its the bearing edge on the snare side (bottom). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |